The adjustable clasp is a pulley mechanism that is built into the cord. Bracelets with this clasp come in one size that you can adjust to fit your wrist by pulling the two loose ends until it fits perfectly. The metal clasp is a made up in the material of your choice (silver, yellow, rose or white gold) and closes by inserting the one clasp into a hole in the other. Note: Bracelets with this clasp are made to fit to the exact size of the wrist. Please see our sizing recommendations below.

When you order your piece we request that you provide us with the measurement around your wrist in cm's so that we can size it for you. This can be done by using either a piece of string, strip of paper or a measuring tape. Step 1: Using a flexible measuring tape, string or strip of paper, measure your wrist just around the wrist bone or where you would like to wear the bracelet. Step 2: If using a flexible measuring tape, mark down your measurement where the string meets the end. If utilizing a string or strip of paper measure the length the same way you would with a piece of string. You can then use these to measure againt your ruler. When measuring remember you want the piece to fit comforatbly and not too tight. For more tips on how to measure your wrist you can watch the video below. https://www.youtube.com/watch?v=4kZkaRJQS5U PLEASE NOTE: The piece will be made according to the masurements you supply when you order. Should your order arrive and your piece be too small, but the correct length according to the measurements that you have supplied then the cost of the courier, redelivery and re-stringing will be for your account and must be paid before the piece will be collected. Should the error be on our side then BCP shall cover the cost of the courier, redelivery and re-stringing.

Sometimes when you receive a piece it may a bit too loose around your wrist. You can adjust the length of the cord by following instructions below. Please note should you make an error and cut the cord too short, you the customer will be responsible the cost of replacing the the cord including courier and redelivery fees as well as the cost of restringing all of which must be paid before collection Items you will need: 1) Lighter 2) Tape 3) Sharp scissors or blade 4) Plate Step 1: Measure the bracelet around your wrist and mark where you want the cord to end. The bracelet should be comfortable when worn. Add approximately 5mm of extra cord on the end of your measurement where you have made your mark Step 2: Make sure to push the clasp on the side you are going to cut to the opposite end that you intend to cut. Place a piece of tape around the cords just below where you intend to cut in order to keep them together. Next use a sharp pair of scissors or a blade to cut the cord to the new desired length. Step 3 Using the lighter hold the flame approximately 2cm's below the cord ends for a few seconds. The cord should begin to melt. If it is melting too quickly, pull the flame further away and blow on it. Step 4 Extinguish the flame and quickly press the the melted cords against the side of your lighter or against a non-flammable surface like a plate. Be careful as this may be hot. Touch it quickly to determine if it is too hot. If it is, give it a few seconds to cool, but do not allow it to get cold. Press the ends together to create a solid end. This should now create a solid 'disc' with the clasp unable to pass through. Watch this video on how to: